Double-tap to set the subnet mask.
Match your Art-Net devices' IP to be in the same range as the console. (for example set the
Console IP to 10.0.0.101 and Art-Net device IP to 10.0.0.102, with both using a 255.0.0.0 subnet)
Next, Set or check the DMX output on the console. From the Settings menu, go to DMX
settings.
Set Send Over Network to Yes
Set Art-Net Universe, Art-Net universes start at Universe 0. If your node has been set to
receive Art-Net Universe 0, you would have console universe 1 being sent out on Art-Net
Universe 0.
Network
The Network Settings Window allows users to configure both a wired and a wireless network
connection.
The Wired connection window can be used to define the console’s IP address and subnet
mask. These can be adjusted by pressing within the text boxes and entering the values with
the pop-up keyboard.
2021-03-12
QuickQ v6
47
To Next Page
Loading...
Need help?
General
