• L2TP - Layer 2 Tunneling Protocol (L2TP) is a tunneling
protocol used to support virtual private networks
(VPNs). It does not provide any encryption or
confidentiality by itself. It relies on an encryption
protocol that it passes within the tunnel to provide
privacy.
• Cellular Modem - Connect to the Internet using a
wireless modem to a cellular ISP through the USB port.
• Analog Modem - Connect to the Internet using an
analog modem through a USB port. In the WebUI
application, you can configure to use an analog modem
through the serial port.
• VDSL/ADSL IPoE - IP over Ethernet over DSL system
where the IP is provided by the service provider. Note -
In the First Time Configuration Wizard, only dynamic IP
is supported.
• Bridge - Connects multiple network segments at the
data link layer (Layer 2).
• Wireless - Connects to a wireless network. Connection
through the wireless interface in the First Time
Configuration Wizard is always DHCP.
• DNS Server (Static IP and Bridge connections) - Enter
the DNS server address information in the relevant
fields. For DHCP, PPPoE, PPTP, L2TP, VDSL, Analog
Modem, and Cellular Modem, the DNS settings are
supplied by your service provider. You can override
these settings later in the WebUI application, under
Device > DNS.
For PPPoE over VDSL/ADSL or VDSL/ADSL IPoE:
• ADSL (ATM) system - Enter the VPI number and VCI
number you received from your service provider, and
the Encapsulation type (LLC or VC_MUX).
To Next Page
Loading...
