Edge/Edge Blanket Introduction
1-1
Chapter 1
INTRODUCTION
This chapter contains the following sections:
1.1 Warranty
1.2 Scope of Manual
1.3 Safety
1.4 Equipment Description
The Edge
®
and Edge
®
Blanket automatic spreader/feeders allow operators to feed wet sheets, tumble-
dried blankets, or other large pieces of flatwork into a flatwork ironer or automatic folder. Because
operators do not need to locate and clip one or more corners during loading, each operator can feed
substantially more pieces per hour than using a traditional automatic feeder.
Like the rest of the CHICAGO
®
product line, the Edge and Edge Blanket are designed, manufactured,
and assembled in Chicago, Illinois. Before the CHICAGO
®
nameplate is affixed to any machine, a final
inspection is performed, including thorough testing under load conditions.
Any questions concerning the installation, operation, or repair of the unit should be directed to a local
authorized CHICAGO
®
dealer or the Chicago Dryer Company factory Service Department at:
Chicago Dryer Company (773) 235-4430
2200 North Pulaski Fax (773) 235-4439
Chicago, Illinois USA 60639-3737 Email service@chidry.com
Figure 1-1: The Edge provides high quality spreading and feeding.
To Next Page
Loading...
