Chroma 19572 - Recall Memory; Store Memory; PRESET Testing; How to Enter PRESET Setting Menu

Ground Bond Tester 19572 User’s Manual
4-6
which want to delete. Press Function Key [SELECT] will show a delete confirmation
screen.
3. Press Function Key [YES] to confirm or press Function Key [NO] to cancel.
4.5.3 Recall Memory
If there are a lot of test parameter values in the main memory. Follow the below procedures to
recall test parameter.
1. When the status list shows “SELECT FUNC.”, press Function Key [RECALL].
2. By using Function Key [UP], [DOWN] to select the test parameter data of the memory
which want to recall.
3. Press Function Key [SELECT] will show a recall confirmation window.
4. Press Function Key [YES] to confirm or press Function Key [NO] to cancel.
4.5.4 Store Memory
If you want to store the test parameter set in the memory. Please follow the procedures below
to process.
1. When the status list shows “SELECT FUNC.”, press Function Key [STORE] .
2. By using Function Key [UP], [DOWN] to select the memory which want to store. Press
Function Key [SELECT] the highlight becomes a blinking underline.
3. By using Function Key [UP], [DOWN] to input the memory name in the meantime.
4. By using Function Key [ENTER] to move the blinking underline highlight to the next
position of character.
5. If press Function Key [ENTER] twice continuously, and then will show a store confirmation
window.
6. Press Function Key [YES] to confirm or press Function Key [NO] to cancel.
If there is data in the memory, it will be overlapped. Please confirm
carefully before storing.
4.6 PRESET Testing
4.6.1 How to Enter PRESET Setting Menu
1. In power on menu, press Function Key [PRESET] then enter PRESET setting menu, the
menu display as below:
UP
1.PASS HOLD
:
0.5
sec
2.STEP HOLD
:
0.2
sec
DOWN
3.JUDG. WAIT
:
0.3
sec
4.GB FREQ.
:
60
Hz
ENTER
5.GB VOLTAGE
:
6.0
V
EXIT
0.2-99.9 RMT LOCK OFST ERR
CAUTION