Chroma 19572 - GPIB Related Panel Description; Address Setting; Remote; Local

Ground Bond Tester 19572 User’s Manual
6-2
6.3 GPIB Related Panel Description
6.3.1 Address Setting
1. Under power on menu, press Function Key MENU as the following shown:
UP
1.
MEMORY
2.
SYSTEM
DOWN
3.
OPTION
4.
CALIBRATION
SELECT
5.
KEY LOCK
EXIT
SELECT FUNC.
RMT
LOCK
OFST
ERR
2. Move the highlight to "OPTION" by Function Key UP, DOWN. Press Function Key
SELECT to enter OPTION selection setting as the following shown:
UP
1.RS232
2.GPIB
DOWN
3.PRINTER
SELECT
EXIT
RMT
LOCK
OFST
ERR
3. Move the highlight to "GPIB" by Function Key UP, DOWN. Press Function Key SELECT
to enter GPIB setting menu as the following shown:
UP
1.GPIB ADDR.: 3
DOWN
ENTER
EXIT
RMT LOCK OFST ERR
4. Then select GPIB Address by Function Keys UP, DOWN.
5. The setting is completed, presses Function Key EXIT to exit.
6.3.2 Remote / Local
1. The signal block Remote is highlighted, it means the tester is on Remote status.
2. On Remote status can use Function Key LOCAL to switch the tester to Local status.