Chroma 19572 - Operation Method

Ground Bond Tester 19572 User’s Manual
4-8
STEP 1 GB
LOW : OFF
UP
CURR
：
3.00A
MORE..
HIGH
：
500mΩ
TIME
：
3.0s
ENTER
EXIT
PROCESS STEP RMT LOCK OFST ERR
2. Enter PROGRAM setting menu, the test procedures increase by using Function Key
[UP], the range is from 1∼99.
3. Press [ENTER] to move the highlight to the other parameter want to set.
4. Can switch Function Key menu by using Function Key [MORE..], as shown below:
STEP 1 GB
LOW : OFF
DELETE
CURR
：
3.00A
INSERT
HIGH： 500mΩ
TIME
：
3.0s
DOWN
MORE..
PROCESS STEP RMT LOCK OFST ERR
5. By using Function Key [DOWN] can decrease the test step want to set, the range is 1∼99.
6. By using Function Key [DELETE] and [INSERT] can delete and insert a test step.
7. Press Function Key [MORE..] can return to the previous Function Key menu, and
continue to set the other test parameter.
4.7.2 Operation Method
1. Enter PROGRAM setting menu, move the highlight to the parameter you want to set by
pressing [ENTER].
2. Press Function Key [UP] or [DOWN] to set the parameter.