Chroma 19572 - Printer Function (Option)

Printer Function (Option)
7-1
7. Printer Function (Option)
Preface
The user can connect printer (any brand printer except for HP) to print test parameter setting
value or test result report.
How to print test parameter setting value?
1. Under power-on screen, press Function Key F3 MENU then move the cursor to 8. PRINT
PROGRAM.
2. Press Function Key F3 SELECT, connect the correct printer then will auto print out the test
parameter setting value in the memory.
How to print test result report?
After setting printer print parameter, follows normal test procedures to test. When test is
completed according to the user setting, connect the correct printer to print out test result
report.
Enter printer print parameter setting screen.
1. Under power-on screen, press Function Key MENU then move the cursor to 3. OPTION.
2. Press Function Key SELECT, then move the cursor to 3. PRINT.
3. Press Function Key F3 SELECT, then start to set print parameter.
How to set printer print parameter?
1. By using Function Keys UP, DOWN to set various parameter data.
2. By using Function Key ENTER to move the cursor.
3. By using Function Key EXIT to exit this screen.
Print parameter description:
A. AUTO PRINT - - includes the following two parameters for setting print test result report
timing.
1. PASS: OFF - - When setting is ON, the test result is PASS will print out the test
result report.
2. FAIL: OFF - - When setting is ON, the test result is FAIL will print out the test result
report.
3. F .FEED: OFF - - When setting is ON, end the print and printing paper will skip to
another page.
B. PRINT DATA - - Includes the following five parameters for setting print test result report
that includes data.
1. PART NO.: OFF -- When setting is ON, the test result report will print PART NUMBER.
2. LOT NO.: OFF -- When setting is ON, the test result report will print LOT
NUMBER.
3. SERIAL NO.: OFF -- When setting is ON, the test result report will print SERIAL
NUMBER.
4. TEST DATA: OFF -- When setting is ON, the test result report will print STEP, MODE
and current/resistance data.
5. RESULT: OFF -- When setting is ON, the test result report will print the test result is
PASS or FAIL.