Chroma 61503 - Page 11

ix
Revision History
The following lists the additions, deletions and modifications in this manual at each revision.
Date Version Revised Sections
Jan. 2002 1.0 Complete this manual.
Jan. 2004 1.1 Modify “Rear Panel”
“DATALOCK”
“COUPLE Mode of Output (AC+DC, AC, DC)”
“Programmable Output Impedance”
“THREE PHASE MODE”
“PARALLEL MODE”
“Synthesis Waveform”
“Interharmonics Waveform”
“The GPIB Capability of the AC Source”
May 2005 1.2 Change the address and phone no. of Chroma
Aug. 2005 1.3 Modify “Rear Panel”
“Input Connection”
“Remote Sense Connection”
“COUPLE Mode of Output (AC+DC, AC, DC)”
“THREE PHASE MODE”
“PARALLEL MODE”
June 2007 1.4 Add the following
− “Material Contents Declaration”
− “Protection Plates”
− “HIGH VOLTAGE OPTION”.
− the description of “NOTICE” in the section of “OUTPUT
RELAY”
Modify the following chapters
− the figure 3-1 in the section of “Operation through Keypad and
RPG”.
− “the definition of letters” in the section of “MAIN PAGE (Output
Setting and Measurement)”.
− the content and notice in the section of “RANGE”.
− “CALIBRATION CHOICE PAGE” in the section of “MANUAL
CALI Functional List”.
− the waveform and table list in the section of “Appendix B
Built-in Waveforms”.
Mar. 2008 1.5
Add the following
– the description in the section of “Slew Rate of Output
Transient”.
– Notice in the section of “HIGH VOLTAGE OPTION”.
– the description in the section of “Appendix A: Pin Assignment
of TTL SIGNAL”.
Modify the following sections:
– Range of OUTPUT IMPEDANCE in the section of
“Specifications”.
– the second page display in the section of “OUTPUT Functional
List”.
– DST17 in the section of “Appendix B Built-in Waveforms”.
Jan. 2010 1.6 Modify the following sections:
– the description in the section of “Procedures of Power-on”.