Chroma 61705 - Page 82

Programmable AC Source 61705 User’s Manual
8-8
Too Many Errors
Execution Error
SYSTem : VERSion?
Description : This query requests the AC Source to identify itself.
Query Syntax : SYSTem : VERSion?
Parameters : NONE
Return Parameters :
SYSTem : LOCal
Description : This command can only be used under the control of RS-232C.
If SYST: LOC is programmed, the AC Source will be set in the
LOCAL state, and the front panel will work.
Query Syntax : NONE
Parameters : NONE
Return Parameters : NONE
SYSTem : REMote
Description : This command can only be used under the control of RS-232C.
If SYST: REM is programmed, the AC Source will be set in the
REMOTE state, and the front panel will be disabled except the
“<PAGE/EXIT> key.
Query Syntax : NONE
Parameters : NONE
Return Parameters : NONE
8.6.2.2 INSTRUMENT Sub-system
INSTrument
: COUPle
: NSELect
: SELect
: PHASe
: SLAVE1
: SLAVE2
INSTrument : COUPle
Description : In a multi-phase power source it is convenient to set parameters
for all phases simultaneously with one programmed command.
When INST: COUP ALL command is programmed, a command
will be sent to the AC Source, and to all phases in the end.
INST: COUP NONE command cancels COUP ALL command.
This command affects the set voltage only.
Query Syntax : INSTrument : COUPle?
Parameters : ALL | NONE
Return Parameters : NONE
INSTrument : NSELect
Description : This command sets individual outputs in a multi-phase model
for subsequent commands or queries. If INST: COUP NONE