Digital Power Meter 66200 Series User’s Manual
Setting Parameters: none
Query Syntax: none
Response Parameters: none
Example: none
SYSTem : REMote 66201 | 66202
Description: This command can only be used under control of USB. If SYST:REM is
programmed, the Power Meter will be set in the REMOTE state, and the front
panel will be disabled except the <SETUP>key pressed.
Setting Syntax:
SYSTem:REMote<PMT>
Setting Parameters: none
Query Syntax: none
Response Parameters: none
Example: none
STATUS Sub-system
STATus : OPERation [ : EVENt ]? 66201 | 66202
Description: This command queries the Operation Status register.
Setting Syntax:
none
Setting Parameters: none
Query Syntax: STATus:OPERation?<PMT>
Response Parameters: <NR1>, 0
Header on: :STATUS:OPERATION:EVENT<space><NR1><RMT>
Header off: <NR1><RMT>
Example: none
STATus : OPERation : ENABle 66201 | 66202
Description: This command sets the Operation Status Enable register. The register is a mask
which enables specific bits from the Operation Status register.
Setting Syntax:
STATus:OPERation:ENABle<space><NR1><PMT>
Setting Parameters: <NR1>, 0 ~ 255
Query Syntax: STATus:OPERation:ENABle?<PMT>
Response Parameters: <NR1>, 0 ~ 255
Header on: :STATUS:OPERATION:ENABLE<space><NR1><RMT>
Header off: <NR1><RMT>
Example: none
STATus : QUEStionable [ : EVENt ]? 66201 | 66202
Description: This query returns the value of the Questionable Event register. The Event
register is a read-only register which holds all events that are passed by the
Questionable NTR and/or PTR filter. If QUES bit of the Service Request Enable
register is set, and the Questionable Event register > 0, QUES bit of the Status
Byte register is set too.
Setting Syntax: none
Setting Parameters: none
Query Syntax: STATus:QUEStionable?<PMT>
5-12
To Next Page
Loading...
Need help?
General
