7 EN
COFFEE CIRCUIT / MILK CIRCUIT / SOLUBLES CIRCUIT
• Press the PRG (29)
key and then the icon ; choose the type of wash cycle, and follow the instructions on the
touch screen.
HOT WATER
• Continuously dispense hot water
until at least 0.5 liters of water have been dispensed
.
WARNING: AFTER INSTALLATION, CHECK TO SEE IF THE MACHINE IS WORKING PROPERLY (see the
Installation Module C).
WARNING: ONCE THE MACHINE HAS BEEN INSTALLED AND IS READY FOR USE, BEFORE ALLOWING
THE WORKER TO START USING THE MACHINE, WASH THE INTERNAL COMPONENTS ACCORDING
TO THE INSTRUCTIONS BELOW:
WATER CONNECTIONS
• No leaks from the connections or tubes
FUNCTIONING
• Boiler and operating pressures are normal.
• The pressure gauge is working properly.
• The self-leveling device is working properly.
• The expansion valves are working properly
5. Installation Check-up
To Next Page
Loading...
