26 EN
Use a brush to clean all the holes where the liquid passes through and clean
also the silicon pipe (S) .
• Place ½ liter of cold water into a container and add a dose of liquid detergent (see product instructions).
• Wash the separte parts, removing any organic residue with a sponge.
• Immerse all mixer parts in the solution (water – detergent) for at least 15 minutes.
• Remove all parts from the solution and rinse.
Reassemble the parts and attach the mixer to its base.
Note: Take care when reattaching the mixer blade (4) to the pin (PDQGPDNHVXUHWKHWZRÀDWSDUWVRQWKHFRPSRQHQWV
match.
Note: Take care when reattaching the mixer conveyor (3) to water nozzle (H).
After the machine has returned to its normal working conditions, perform a washing cycle following the instructions
described previously.
To Next Page
Loading...
