91
Update
Chapter 3
Setting up a WPAN Connection
3.2 CONNECTING VIA BLUETOOTH
®
DONGLE
3.2.1 CHANGE INTERFACE
Below is the procedure to configure the scanner before establishing a WPAN connection
via a generic Bluetooth
®
dongle.
1) Have the scanner read the “Enter Setup” label to enter the configuration mode.
2) Have the scanner read the desired interface label –
“Activate BT HID & Select Keyboard Type”
“Activate BT SPP”
3) Have the scanner read the labels related to WPAN settings, such as Device Name
Broadcasting, Authentication & PIN Code, etc.
4) Have the scanner read the “Update” label to exit the configuration mode.
5) The scanner will stay active for a specified period of time (2 minutes by default)
waiting for a connection request from the host (SPP) or trying to connect to the host
(HID). Its CPU is running at full speed, and the LED is flashing blue (On/Off ratio 0.5
s: 0.5 s).
Once connected, when getting out of range, the scanner will respond with three short
beeps (tone descending from high to low).
To Next Page
Loading...
