37
Update
Chapter 1
Understanding the Barcode Scanner
1.7 SCANNING TIMEOUT
Specify the scanning time interval (1~254 sec.; 0= Disable) when the scan mode is set
to any of the following –
Laser mode
Auto Off mode
Auto Power Off mode
Aiming mode
1) Read the label above to specify the time interval before the scan engine times out.
2) Read the “
Decimal Value” label on page 205. For example, read “1” and “5” for the
scanner to automatically shut down after being idle for 15 seconds.
3) Read the “Validate” label on the same page to complete this setting.
Scanner Time-Out after 0~25
seconds (*10)
To Next Page
Loading...
Need help?
General
