11
Update
Quick Start
ENTER CONFIGURATION MODE
For the scanner to enter the configuration mode, you must have it read the “Enter Setup”
label, which can be located at the bottom of almost every even page of this manual.
The scanner will respond with six beeps and its LED indicator will become flashing red
after reading the label.
For configuring scanner parameters, see “Read a Setup Label” below.
EXIT CONFIGURATION MODE
For the scanner to save settings and exit the configuration mode, you must have it read
the “Update” label, which can be located at the bottom of almost every odd page of this
manual. If you want to exit the configuration mode without saving any changes, have the
scanner read the “Abort” label instead.
Just like reading the “Enter Setup” label, the scanner will respond with six beeps and
its LED indicator will become flashing red after reading the label. Wait for a few
seconds for the scanner to restart itself.
Update
Abort
nter Setup
To Next Page
Loading...
