Circutor WIBEEE Series - 4.5. START-UP

20
Wibeee
Instruction Manual
Table 10: Description of the LEDs�
LED Description
Red Blinking light: Powered device.
Blue
Indicates the connection status:
Slow blinking light (1s): Generating a Wi-Fi network.
Fast blinking light (<1s) : Connected to a Wi-Fi network.
Steady light: Data being sent over the network.
4.4.- BUTTON
The device has a Reset button, Figure 16, to restore the device's factory settings (hold it down
for more than 6 seconds).
Reset
Reset
L2
L3
Reset
Figure 16:Reset Button�
4.5.-START-UP
During the start-up of the device, the Wibeee goes through different states:
1�- Conguration state
Blue LED→Slowblinkinglight(1s)
Red LED→Slowblinkinglight(1s)
In this state, the Wibeee generates its own Wi-Fi network called WIBEEE_xx:xx:xx�
Itisonlyusedtocongurethedeviceandconnectittotheuser'snetwork.
If you want to return to this state to obtain the initial conditions, you should hold down the Re-
set button for more than 6 seconds. The device deletes any previous settings and restores the
default values.
2�- Connecting��� state
Blue LED→Off
Red LED→Slowblinkinglight(1s)
In this state, the Wibeee is managing the connection with the router/access point.
This state should last for 40 seconds, when there is good Wi-Fi coverage. In places where there
is weak Wi-Fi coverage, it may take longer.