Cisco 1552S - Appendix; Access Point Specifications

D-17
Cisco Aironet 1552 Series for Hazardous Locations Installation Guide
APPENDIX
D
Access Point Specifications
Table D-1 lists the technical specifications for the Cisco Aironet 1552 Outdoor Mesh Access Points for
Hazardous Locations. For detailed specifications, refer to the Cisco Aironet 1550 Series Outdoor Access
Point data sheet at:
http://www.cisco.com/en/US/prod/collateral/wireless/ps5679/ps11451/data_sheet_c78-641373.html
Table D-1 Access Point Specifications
Category Specifications
Size 12.0 in. x 7.8 in. x 6.4 in. (30.48 cm x 19.81 cm x 16.26 cm) (including antenna mount)
Weight
• 1552SA/1552SD (AC): 18.5 lbs (8.4 kg)
• 1552SA/1552SD (DC): 17.5 lbs (7.9)
• 1552H: 17.6 lbs (8 kg)
• 1552WU: 17.6 lbs (8 kg)
• Pole mounting bracket: 6.1 lbs (2.8 kg)
Connector
• 1552H: Three Type N antenna connectors for 2.4 GHz radio and 5 GHz 802.11n radio (depends
on configuration)
• 1552S: Five Type N antenna connectors for 2.4 GHz radio and 5 GHz 802.11n radio (depends
on configuration)
• 1552WU: Seven Type N antenna connectors for 2.4 GHz radio and 5 GHz 802.11n radio
(depends on configuration)
• 1552S: Two Type N antenna connector (2.4 GHz ISA100 Wireless and WirelessHART
Multiprotocol radio)
• Internal PoE In or ETH connector (uplink port)—RJ-45 connector
• Internal PoE Out connector (downlink port)—RJ-45 connector
• 1552H and 1552S: Optional internal SFP fiber module—LC fiber connector
• 1552WU: 2.4 GHz WirelessHART radio for communicating with sensor devices by a single
Type N connector for the WirelessHART 2.4 GHz antenna. This antenna is intended to be
connected using a low-loss coaxial cable.