2-31
Cisco Aironet 1552 Series for Hazardous Locations Installation Guide
Chapter 2 Before You Begin
Tools and Hardware
• Optional pole mount kit (AIR-ACCPMK1550=, AIR-ACCPMK1550HZM=)
• Optional banding strap tool (BAND IT) (AIR-BAND-INST-TL=)
Optional Tools and Hardware That You Supply
Tools and materials that are user-supplied are:
• Ground lug crimping tool (Panduit CT-720 with CD-720-1 die)
• 6-AWG copper ground wire
• 13 mm box-end wrench or socket set
• Adjustable wrench, 22 mm socket, or Sealcon S-2200-WR socket wrench
• #8 Torx screwdriver
• Torque Wrench (ft-lbs)
• Small flat screwdriver for DC power connector
• Optional shielded outdoor-rated Ethernet (CAT5e or better) cable with 0.20 to 0.35 in
(0.51 to 0.89 cm) diameter
• Optional Ethernet RJ-45 connector and installation tool
• Optional shielded outdoor-rated DC power cable with 0.20 to 0.35 inch (.0.51 to 0.89 cm) diameter
• Optional ground rod, as required by local regulations
• Optional ladder, power lift, rope, or other tools as required
Pole Installation Hardware and Tools
To install the access point on a vertical or horizontal metal, wood, or fiberglass pole, you need the
following additional hardware and tools:
• Pole mount kit (AIR-ACCPMK1550=, AIR-ACCPMK1550HZM=)
–
Pole clamp bracket
–
Two gusset strap brackets
–
One mounting bracket
–
Twelve hex bolts (M8 x16)
–
One M8 flange nut
–
Six M8 flat washers
–
Ten M8 split lock washers
–
Two stainless steel mounting straps
• Customer banding strap tool (BAND IT)—(AIR-BAND-INST-TL=)
• Customer-supplied 13-mm and box-end wrench or socket set
• Customer-supplied adjustable wrench, 22 mm socket, or Sealcon S-2200-WR socket wrench
To Next Page