1-6
Cisco Aironet 1552 Series for Hazardous Locations Installation Guide
Chapter 1 Overview
Hardware Features
Table 1-2 Components of Each 1552 Access Point Model
Note All models support 12 VDC power input, but this feature cannot be used in hazardous locations.
Note There is no battery backup option for these models.
Regulatory Domains
The “-x” in the 1552 model numbers represent the domain. For example, in AIR-CAP1552H-x-K9 the
-x represents a regulatory domain for a specific country.
For specific regulatory domains supported by each 1552 access point model, refer to the Wireless LAN
Compliance Status at:
http://www.cisco.com/en/US/prod/collateral/wireless/ps5679/ps5861/product_data_sheet0900aecd805
37b6a.html
To locate the 1552 access point models, click on 802.11abgn Mesh Access Points.
Hardware Features
This section describes the hardware features of the 1552 access point models. The following hardware
features are described in this section:
• Connectors, page 1-7
1552H 1552SA/1552SD 1552WU
Antennas External External External
Fiber SFP Yes Yes No
PoE Out Port
802.3af (For example, an IP
video camera or VOIP Phone)
When powered with PoE, the
PoE Out port is not active.
Yes Yes
Hazardous Locations
Class 1 Div2/Zone2
Yes Yes Yes
Power Options AC and PoE
Note PoE In is not 802.3af. It
cannot be powered by an
IEEE 802.3af/at-based
PoE Ethernet switch. It
requires the dedicated
Power Injector
(AIR-PWRINJ1500-2=)
.
SA Model: AC
SD Model: 24V DC
24 VDC
To Next Page
Loading...
