1-27
Cisco Aironet 1552 Series for Hazardous Locations Installation Guide
Chapter 1 Overview
Hardware Features
There are four role based user accounts for the gateway with varying levels of access. The table below
describes this access.
Note Each of the initial passwords for the user accounts is “default.” It is recommended, for security purposes,
that these passwords are changed. The administrator password should be appropriately noted when
changed. If it is lost, please contact Emerson Process Management for technical support.
To change the User Accounts Passwords:
Step 1 Navigate to Setup>Security>User accounts.
Step 2 Set the new password for each role based user account, and confirm.
Step 3 Click Submit.
Role User Name Web Interface Access
Executive exec Read-only access
Operator oper Read-only access
Maintenance maint Configure HART® device settings
Configure Modbus communications
Configure Modbus register mapping
Configure OPC browse tree
Configure Active Advertising
Administrator admin Includes all maintenance privileges
Configure Ethernet network settings
Configure WirelessHART network settings
Set passwords
Set time settings
Set home page options
Configure custom point pages
Restart applications
To Next Page
Loading...
