Cisco 2600 Series Hardware Installation Guide

Index
IN-5
Cisco 2600 Series Routers Hardware Installation Guide
OL-2171-02
overview of Cisco 2600 series routers 1-1
P
permanent ground warning 3-15
power
environment considerations
2-4
power disconnect warning 3-16
power supply, DC 3-13
power supply warning 2-2
precautions, operating environment 2-4
preparing to install the Cisco 2600 series routers 2-1
procedures
installation
3-1
maintenance B-1
opening the chassis B-3
replacing
chassis cover
B-34
system-code SIMMs B-14
troubleshooting A-1 to A-2
Q
qualified personnel warning 2-2, 3-1
R
rack equipment
installation
3-4
rear panel
Cisco 2600 series 1RU (figure)
1-2
Cisco 2600 series 2RU (figure) 1-3
recovering boot and system images C-6
regulatory compliance 1-5
related documentation xi
Removing and Installing SDRAM DIMMs (figure) B-13
removing SDRAM DIMM modules B-12
Removing the Cisco 2691 Router Cover (figure) B-5
Removing the Cover from a Cisco 2691 (figure) B-19
Removing the ROM from the Cisco 2600 series system
board (figure)
B-32
removing the router cover B-3
replacing
cover
B-34
Flash memory SIMM B-16
system-code SIMMs B-14
requirements, site 2-3
reset command C-4
restricted access warning 3-12
rollover cable (figure) 3-20
rollover cable, identifying 3-20
ROM flash, Cisco 2691 B-33
ROM monitor diagnostics C-4
ROM upgrade, Cisco 2691 B-33
rubber feet, installing 3-2
S
Safety
ESD strap
2-3
safety
general guidelines
2-1, 2-5
warnings 2-1
safety warnings ix
SDRAM 1-2
configurations for Cisco 2691 routers (table) B-11
DIMM (figure) B-12
DIMM Locations in the Cisco 2691 Router
(figure)
B-11
installation B-13
orientation B-11
SELV circuit warning 2-5
serial connections, considerations 2-7
serial port specifications 2-8
service personnel warning 2-2
SIMM
handling caution
B-16

Cisco 2600 Series Specifications

General

Brand	Cisco
Model	2600 Series
Category	Network Router
Language	English