Cisco 3200 - Cleaning the Camera Lens; Maintaining the Projector

11-2
Cisco TelePresence System 3200
OL-14521-01
Chapter 11 Use & Care Guide
Cleaning the Camera lens
Cleaning the Camera lens
Caution Do not touch the camera after installation is completed. If you need to clean the camera lens, use a dry
microfiber cloth. After cleaning, you will need to realign the camera.
Maintaining the Projector
Note Refer to the Projector User Guide included with your projector for maintenance issues such as cleaning
the projector lens. To replace the projector lamp, see the “Replacing the Projector Lamp—Part Number
CTS-PRJTR-BL-GEN1= or CTS-PRJTR-GEN2-CH (China)” section on page 12-25. To replace the
projector, see the “Replacing the Projector—Part Number CTS-PRJTR-GEN1=” section on page 12-27.
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning Installation of the equipment must comply with local and national electrical codes.