Contents
vii
Hardware Installation Guide for the Cisco 4451-X Integrated Services Router
Overview 6-7
LEDs on the NIM-SSD 6-8
Solid State Drives (SSD) 6-10
Installing the SSD Drives into the NIM Carrier Card 6-12
Removing the SSD Drives from the NIM-SSD 6-13
Removing and Replacing the Cisco ISR 4451-X NIM-SSD Drives 6-15
Removing the NIM-SSD from the Router 6-16
Replacing the NIM-SSD on the Router 6-18
Installing and Removing DDR DIMMs 6-18
Locating and Orienting DIMM 6-18
Removing a DIMM 6-20
Installing a DIMM 6-21
Installing and Removing NIMs and SMs 6-23
Software Requirement for SMs 6-24
Locating an SM or NIM 6-24
Removing an SM or NIM 6-24
Installing an SM 6-24
Verifying SM Installation 6-25
Installing and Removing the PVDM4 6-25
Tools and Equipment Required During Installation 6-26
PVDM4 Location and Orientation 6-26
Installing the PVDM4 on the Motherboard of the Cisco ISR 4451-X 6-27
Removing the PVDM4 from the Motherboard of the Cisco ISR 4451-X 6-28
Installing the PVDM4 on the Cisco Fourth-Generation T1/E1 Voice and WAN NIM in the Cisco ISR
4451-X
6-29
Removing the PVDM4 from the Cisco Fourth-Generation T1/E1 Voice and WAN Network Interface
Module in the Cisco ISR 4451-X
6-30
Removing and Replacing the USB Flash Token Memory Stick 6-30
Replacing Power Supplies and Redundant Power Supplies 6-31
Replacing the Cisco ISR 4451-X Power Supply 6-31
Replacing the Power Supply on the Cisco ISR 4451-Xs 6-33
Inserting PoE Supply in an Ethernet Switch Network Module 6-33
Cisco ISR 4451-X Power and RPS Error Messages 6-34
Replacing a Fan Tray 6-34
Before Hot-Swapping a Fan Tray 6-34
Replacing the Cisco ISR 4451-X Fan Tray 6-34
Removing and Installing a CompactFlash Memory Card 6-36
Preventing Electrostatic Discharge Damage 6-36
Removing a CompactFlash Memory Card 6-36
To Next Page
Loading...
