Index
IN-15
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
OL-4266-08
PFC2
NetFlow
table, displaying entries 6
PFC3BXL
hardware features 5
MPLS guidelines and restrictions 7
MPLS label switching 1
MPLS supported commands 7
recirculation 4
supported Cisco IOS features 5
VPN supported commands 11
VPN switching 10
PIM, IP MMLS and 10
PIM snooping
designated router flooding 6
enabling globally 5
enabling in a VLAN 5
overview 4
platform ipv4 pbr optimize tcam command 4
police command 78
policing
See QoS policing
policy 66
policy-based routing
See PBR
policy enforcement 6
policy map 74
attaching to an interface 81
policy-map command 67, 74
Port Aggregation Protocol
see PAgP
port-based authentication
authentication server
defined 2
RADIUS server 3, 2
client, defined 2
configuration guidelines 6
configuring
initializing authentication of a client 11
manual reauthentication of a client 11
quiet period 12
RADIUS server 10
RADIUS server parameters on the switch 9
switch-to-authentication-server retransmission
time
14
switch-to-client EAP-request frame retransmission
time
13
switch-to-client frame-retransmission number 14
switch-to-client retransmission time 12
default configuration 6
described 1
device roles 2
displaying statistics 16
EAPOL-start frame 3
EAP-request/identity frame 3
EAP-response/identity frame 3
enabling
802.1X authentication 7, 9
periodic reauthentication 10
encapsulation 3
initiation and message exchange 3
method lists 7
ports
authorization state and dot1x port-control
command
4
authorized and unauthorized 4
resetting to default values 15
switch
as proxy 2
RADIUS client 2
topologies, supported 5
port-based QoS features
see QoS
port channel
switchport trunk encapsulation dot1q 6
port-channel
see EtherChannel
port-channel load-balance
command 10, 11
To Next Page