CHAPTER
24-1
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
OL-4266-08
24
Configuring PFC3BXL and PFC3B Mode
Multiprotocol Label Switching
This chapter describes how to configure PFC3BXL and PFC3B mode Multiprotocol Label Switching
(MPLS) on a Cisco 7600 series router.
Note For complete syntax and usage information for the commands used in this chapter, refer to these
publications:
• The Cisco IOS Master Command List, Release 12.2SX at this URL:
http://www.cisco.com/en/US/docs/ios/mcl/122sxmcl/12_2sx_mcl_book.html
• The Release 12.2 publications at this URL:
http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_installation_and_configuratio
n_guides_list.html
This chapter consists of these sections:
• PFC3BXL and PFC3B Mode MPLS Label Switching, page 24-1
• PFC3BXL or PFC3B Mode VPN Switching, page 24-10
• Any Transport over MPLS, page 24-13
Tip For additional information (including configuration examples and troubleshooting information), see the
documents listed on this page:
http://www.cisco.com/en/US/products/hw/routers/ps368/tsd_products_support_series_home.html
PFC3BXL and PFC3B Mode MPLS Label Switching
These sections describe PFC3BXL and PFC3B mode MPLS label switching:
• Understanding MPLS, page 24-2
• Understanding PFC3BXL and PFC3B Mode MPLS Label Switching, page 24-2
• Supported Hardware Features, page 24-5
To Next Page
Loading...
