46-16
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
OL-4266-08
Chapter 46 Configuring IEEE 802.1X Port-Based Authentication
Displaying 802.1X Status
Displaying 802.1X Status
To display global 802.1X administrative and operational status for the router, use the show dot1x
privileged EXEC command. To display the 802.1X administrative and operational status for a specific
interface, use the show dot1x interface interface-id privileged EXEC command.
For detailed information about the fields in these displays, refer to the Cisco IOS Master Command List,
Release 12.2SX.
Tip For additional information (including configuration examples and troubleshooting information), see the
documents listed on this page:
http://www.cisco.com/en/US/products/hw/routers/ps368/tsd_products_support_series_home.html
Step 3
Router(config-if)# end
Returns to privileged EXEC mode.
Step 4
Router# show dot1x all
Verifies your entries.
1. type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet
Command Purpose
To Next Page
Loading...
Need help?
General
