17-7
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
OL-4266-08
Chapter 17 Configuring IEEE 802.1Q Tunneling
Configuring 802.1Q Tunneling
To configure the router to tag traffic in the native VLAN, perform this task:
This example shows how to configure the router to tag native VLAN traffic and verify the configuration:
Router# configure terminal
Router(config)# vlan dot1q tag native
Router(config)# end
Router# show vlan dot1q tag native
Tip For additional information (including configuration examples and troubleshooting information), see the
documents listed on this page:
http://www.cisco.com/en/US/products/hw/routers/ps368/tsd_products_support_series_home.html
Command Purpose
Step 1
Router(config)# vlan dot1q tag native
Configures the router to tag native VLAN traffic.
Router(config)# no vlan dot1q tag native
Clears the configuration.
Step 2
Router(config)# end
Exits configuration mode.
Step 3
Router# show vlan dot1q tag native
Verifies the configuration.
To Next Page
Loading...
Need help?
General
