EasyManuals Logo

Cisco 7604 User Manual

Cisco 7604
1011 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #390 background imageLoading...
Page #390 background image
25-16
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
OL-4266-08
Chapter 25 Configuring IPv4 Multicast VPN Support
Configuring MVPN
Enabling IPv4 Multicast Routing Globally
To enable IPv4 multicast routing globally, perform this task:
This example show how to enable IPv4 multicast routing globally:
Router# configure terminal
Router(config)# ip multicast-routing
Enabling IPv4 Multicast VRF Routing
To enable IPv4 multicast VRF routing, perform this task:
When enabling IPv4 multicast VRF routing, note the following information:
vrf_name—Specifies a particular VRF for multicast routing. The vrf_name should refer to a VRF
that has been previously created, as specified in the “Configuring a Multicast VPN Routing and
Forwarding Instance” section on page 25-9.
distributed—(Optional) Enables Multicast Distributed Switching (MDS).
This example show how to enable IPv4 multicast VRF routing:
Router# configure terminal
Router(config)# ip multicast-routing vrf blue
Configuring a PIM VRF Register Message Source Address
To configure a PIM VRF register message source address, perform this task:
This example show how to configure a PIM VRF register message source address:
Router(config)# ip pim vrf blue register-source loopback 3
Command or Action Purpose
Step 1
Router# configure terminal
Enters global configuration mode.
Step 2
Router(config)# ip multicast-routing
Enables IPv4 multicast routing globally.
Router(config)# no ip multicast-routing
Disables IPv4 multicast routing globally.
Command or Action Purpose
Router(config)# ip multicast-routing vrf
vrf_name
[distributed]
Enables IPv4 multicast VRF routing.
Router(config)# no ip multicast-routing
Disables IPv4 multicast VRF routing.
Command or Action Purpose
Router(config)# ip pim vrf
vrf_name
register-source
interface_type interface_number
(Optional) Configures a PIM VRF register message source
address. You can configure a loopback interface as the source
of the register messages.
Router(config)# no ip pim vrf
vrf_name
register-source
Disables IPv4 multicast VRF routing.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 7604 and is the answer not in the manual?

Cisco 7604 Specifications

General IconGeneral
BrandCisco
Model7604
CategoryNetwork Router
LanguageEnglish

Related product manuals