EasyManua.ls Logo

Cisco 7604

Cisco 7604
1011 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
25-18
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
OL-4266-08
Chapter 25 Configuring IPv4 Multicast VPN Support
Configuring MVPN
This example show how to configure an MSDP peer:
Router(config)# ip msdp peer router.cisco.com connect-source fastethernet 1/1 remote-as 109
Enabling IPv4 Multicast Header Storage
To enable IPv4 multicast header storage, perform this task:
When enabling IPv4 multicast header storage, note the following information:
vrf vrf_name—Allocates a buffer for the specified VRF.
rtp—(Optional) Also caches Real-Time Transport Protocol (RTP) headers.
The buffers can be displayed with the show ip mpacket command.
This example show how to enable IPv4 multicast header storage:
Router(config)# ip multicast vrf blue cache-headers
Configuring the Maximum Number of Multicast Routes
To configure the maximum number of multicast routes, perform this task:
When configuring the maximum number of routes, note the following information:
vrf vrf_name— Enables route limiting for the specified VRF.
limit—The number of multicast routes that can be added. The range is from 1 to 2147483647, with
a default of 2147483647.
threshold—(Optional) Number of multicast routes that can be added before a warning message
occurs. The valid range is from 1 to the value of the limit parameter.
This example show how to configure the maximum number of multicast routes:
Router(config)# ip multicast vrf blue route-limit 200000 20000
Command or Action Purpose
Router(config)# ip multicast vrf
vrf_name
cache-headers [rtp]
(Optional) Enables a circular buffer to store IPv4 multicast
packet headers.
Router(config)# no ip multicast vrf
vrf_name
cache-headers [rtp]
Disables IPv4 multicast header storage.
Command or Action Purpose
Router(config)# ip multicast vrf
vrf_name
route-limit
limit
[
threshold
]
(Optional) Configures the maximum number of multicast
routes that can be added for multicast traffic.
Router(config)# no ip multicast vrf
vrf_name
route-limit
limit
[
threshold
]
Clears the configured maximum number of routes.

Table of Contents

Related product manuals