43-7
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
OL-4266-08
Chapter 43 Configuring PFC QoS Statistics Data Export
Configuring PFC QoS Statistics Data Export
Router# show mls qos statistics-export info
QoS Statistics Data Export Status and Configuration information
---------------------------------------------------------------
Export Status : enabled
Export Interval : 250 seconds
Export Delimiter : |
Export Destination : Not configured
QoS Statistics Data Export is enabled on following ports:
---------------------------------------------------------
FastEthernet5/24
QoS Statistics Data export is enabled on following shared aggregate policers:
-----------------------------------------------------------------------------
aggr1M
QoS Statistics Data Export is enabled on following class-maps:
---------------------------------------------------------------
class3
Router#
Configuring PFC QoS Statistics Data Export Destination Host and UDP Port
To configure the PFC QoS statistics data export destination host and UDP port number, perform this task:
Note When the PFC QoS data export destination is a syslog server, the exported data is prefaced with a syslog
header.
Table 43-2 lists the supported PFC QoS data export facility and severity parameter values.
Command Purpose
Step 1
Router(config)# mls qos statistics-export
destination {
host_name
|
host_ip_address
}
{port
port_number
| syslog
[facility
facility_name
]
[severity
severity_value
]}
Configures the PFC QoS statistics data export destination
host and UDP port number.
Router(config)# no mls qos statistics-export
destination
Clears configured values.
Step 2
Router(config)# end
Exits configuration mode.
Step 3
Router# show mls qos statistics-export info
Verifies the configuration.
Table 43-2 Supported PFC QoS Data Export Facility Parameter Values
Name Definition Name Definition
kern kernel messages cron cron/at subsystem
user random user-level messages local0 reserved for local use
mail mail system local1 reserved for local use
daemon system daemons local2 reserved for local use
auth security/authentication messages local3 reserved for local use
syslog internal syslogd messages local4 reserved for local use
To Next Page
Loading...
