43-9
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
OL-4266-08
Chapter 43 Configuring PFC QoS Statistics Data Export
Configuring PFC QoS Statistics Data Export
Setting the PFC QoS Statistics Data Export Field Delimiter
To set the PFC QoS statistics data export field delimiter, perform this task:
This example shows how to set the PFC QoS statistics data export field delimiter and verify the
configuration:
Router# configure terminal
Router(config)# mls qos statistics-export delimiter ,
Router(config)# end
Router# show mls qos statistics-export info
QoS Statistics Data Export Status and Configuration information
---------------------------------------------------------------
Export Status : enabled
Export Interval : 250 seconds
Export Delimiter : ,
Export Destination : 172.20.52.3, UDP port 514 Facility local6, Severity debug
QoS Statistics Data Export is enabled on following ports:
---------------------------------------------------------
FastEthernet5/24
QoS Statistics Data export is enabled on following shared aggregate policers:
-----------------------------------------------------------------------------
aggr1M
QoS Statistics Data Export is enabled on following class-maps:
---------------------------------------------------------------
class3
Tip For additional information (including configuration examples and troubleshooting information), see the
documents listed on this page:
http://www.cisco.com/en/US/products/hw/routers/ps368/tsd_products_support_series_home.html
Command Purpose
Step 1
Router(config)# mls qos statistics-export
delimiter
delimiter_character
Sets the PFC QoS statistics data export field delimiter.
Router(config)# no mls qos statistics-export
delimiter
Reverts to the default PFC QoS statistics data export field
delimiter
Step 2
Router(config)# end
Exits configuration mode.
Step 3
Router# show mls qos statistics-export info
Verifies the configuration.
To Next Page
Loading...
