48-4
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
OL-4266-08
Chapter 48 Configuring CDP
Configuring CDP
This example shows how to clear CDP counter configuration:
Router# clear cdp counters
This example shows how to display information about the neighboring equipment:
Router# show cdp neighbors
Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge
S - Switch, H - Host, I - IGMP, r - Repeater
Device ID Local Intrfce Holdtme Capability Platform Port ID
JAB023807H1 Fas 5/3 127 T S WS-C2948 2/46
JAB023807H1 Fas 5/2 127 T S WS-C2948 2/45
JAB023807H1 Fas 5/1 127 T S WS-C2948 2/44
JAB023807H1 Gig 1/2 122 T S WS-C2948 2/50
JAB023807H1 Gig 1/1 122 T S WS-C2948 2/49
JAB03130104 Fas 5/8 167 T S WS-C4003 2/47
JAB03130104 Fas 5/9 152 T S WS-C4003 2/48
Tip For additional information (including configuration examples and troubleshooting information), see the
documents listed on this page:
http://www.cisco.com/en/US/products/hw/routers/ps368/tsd_products_support_series_home.html
Router# show cdp interface [
type
1
slot/port
}]
Displays information about interfaces on which CDP is
enabled.
Router# show cdp neighbors [
type
1
slot/port
] [detail]
Displays information about neighbors. The display can be
limited to neighbors on a specific interface and expanded to
provide more detailed information.
Router# show cdp traffic
Displays CDP counters, including the number of packets sent
and received and checksum errors.
Router# show debugging
Displays information about the types of debugging that are
enabled. Refer to the Debug Command Reference for more
information about CDP debug commands.
1. type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet
Command Purpose
To Next Page
Loading...
