A-33
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
OL-4266-08
Appendix A Online Diagnostic Tests
Stress Tests
TestIPSecEncryptDecryptPkt
The TestIPSecEncryptDecryptPkt test checks the encryption functionality by exchanging a packet
between the supervisor engine in-band port and the crypto engine of the IPSec services modules
(WS-SVC-IPSEC, SPA-IPSEC) using the switch fabric or bus (whichever is applicable). After several
exchanges, the packet is checked to verify that the original data is preserved after the encryption and
decryption process performed by the crypto engine. The Layer 2 lookup drives the packet between the
supervisor in-band port and the crypto engine.
Stress Tests
The stress tests consist of the following tests:
TestTrafficStress, page A-33
TestEobcStressPing, page A-34
TestTrafficStress
The TestTrafficStress test stress tests the switch and the installed modules by configuring all of the ports
on the modules into pairs, which then pass packets between each other. After allowing the packets to
pass through the switch for a predetermined period, the test verifies that the packets are not dropped.
Ta b l e A-58 TestIPSecEncryptDecryptPkt Test Attributes
Attribute Description
Disruptive/Nondisruptive Nondisruptive. Test runs every minute by default.
Recommendation This test can only be run at bootup.
Default This test runs by default during bootup or after a reset or OIR.
Release 12.2(18)SXE2.2.
Corrective action None. See the system message guide for more information.
Hardware support VPN services module.
Ta b l e A- 5 9 Te s t Tr a f f i c S t r e s s Te s t A t t r i b u t e s
Attribute Description
Disruptive/Nondisruptive Disruptive. Disruption is several minutes.
Recommendation
Use this test to qualify hardware before installing it in your
network.
Default Off.
Release 12.2(18)SXF.
Corrective action Not applicable.
Hardware support Supervisor Engine 720 and Supervisor Engine 32.
To Next Page
Loading...
