Cisco 7604 - Page 978

A-36
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
OL-4266-08
Appendix A Online Diagnostic Tests
General Tests
General Tests
The general tests consist of the following tests:
• ScheduleSwitchover, page A-36
• TestFirmwareDiagStatus, page A-36
ScheduleSwitchover
The ScheduleSwitchover test allows you to trigger a switchover at any time using the online diagnostics
scheduling capability.
TestFirmwareDiagStatus
The TestFirmwareDiagStatus test displays the results of the power-on diagnostic tests run by the
firmware during the module bootup.
Tip For additional information (including configuration examples and troubleshooting information), see the
documents listed on this page:
http://www.cisco.com/en/US/products/hw/routers/ps368/tsd_products_support_series_home.html
Ta b l e A-64 ScheduleSwitchover Test Attributes
Attribute Description
Disruptive/Nondisruptive Disruptive.
Recommendation
Schedule this test during downtime to test the ability of the
standby supervisor engine to take over after a switchover.
Default Off.
Release 12.2(17B)SXA
Corrective action None
Hardware support Supervisor engines only.
Ta b l e A-65 TestFirmwareDiagStatus Test Attributes
Attribute Description
Disruptive/Nondisruptive Nondisruptive.
Recommendation This test can only be run at bootup.
Default This test runs by default during bootup or after a reset or OIR
Release 12.2(18)SXD
Corrective action None. See the system message guide.
Hardware support All modules, including supervisor engines.