Table 15: Recording Mode and Recording Softkeys
Recording Softkeys Available on the PhoneRecording Mode in Server
No softkeys available.
Your user can't control recording from the phone. Recording starts
automatically when a call is connected.
Always
PauseRec
ResumeRec
When a call is connected, recording starts automatically and your user can
control the recording.
Always with Pause/Resume
Record
PauseRec
ResumeRec
When a call is connected, recording starts automatically but the recording
is not saved until the user presses the Record softkey. Your user sees a
message when recording state changes.
On Demand
Record
PauseRec
StopRec
ResumeRec
The recording only starts when your user presses the Record softkey. Your
user sees a message when recording state changes.
On Demand with User Initiated
Start
During a recording, your user sees different icons which depend on the recording state. The icons are displayed
on the Calls screen and also on the line key on which the user is recording a call.
Table 16: Recording Icons
MeaningIcon
Recording in progress.
Recording paused
Before you begin
Access the phone administration web page. See Access the Phone Web Page, on page 80.
Procedure
Step 1 Select Voice > Phone.
Cisco IP Phone 7800 Series Multiplatform Phones Administration Guide
131
Cisco IP Phone Administration
Enable Remote Call Recording with SIP REC
To Next Page
Loading...
Need help?
General
