Cisco 7975G - SIP Configuration Menu (SIP Phones Only); SIP General Configuration Menu

4-14
Cisco Unified IP Phone 7975G Administration Guide for Cisco Unified Communications Manager 6.0
OL-12642-01
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Device Configuration Menu
SIP Configuration Menu (SIP Phones Only)
The SIP Configuration menu is available on SIP phones. This menu contains these sub-menus:
• SIP General Configuration Menu, page 4-14
• Line Settings Menu, page 4-16
SIP General Configuration Menu
The SIP General Configuration menu displays information about the configurable SIP parameters on a
SIP phone.
Table 4-5 describes the options in this menu.
Table 4-5 SIP General Configuration Menu Options
Option Description To Change
Preferred CODEC Displays the CODEC to use when a call
is initiated. This value will always be
set to none.
Display only—cannot configure.
Out of Band DTMF Displays the configuration of the
out-of-band signaling (for tone
detection on the IP side of a gateway).
The Cisco Unified SIP IP phone
supports out-of-band signaling using
the AVT tone method. This value will
always be set to avt.
Display only—cannot configure.
Register with Proxy Displays if the phone must register with
a proxy server during initialization.
This value will always be set to true.
Display only—cannot configure.
Register Expires Displays the amount of time, in
seconds, after which a registration
request expires.
From Cisco Unified Communications
Manager Administration, choose
Device > Device
Settings > SIP
Profile.
Phone Label Displays the text that is displayed on
the top right status line of the LCD on
the phone. This text is for end-user
display only and has no effect on caller
identification or messaging. This value
will always be set to null.
Display only—cannot configure.
Enable VAD Displays if voice activation detection
(VAD) is enabled.
From Cisco Unified Communications
Manager Administration, choose
Device > Device
Settings > SIP
Profile.
Start Media Port Displays the start Real-Time Transport
Protocol (RTP) range for media.
From Cisco Unified Communications
Manager Administration, choose
Device > Device
Settings > SIP
Profile.