Cisco 7975G Administration Guide

xii
Cisco Unified IP Phone 7975G Administration Guide for Cisco Unified Communications Manager 6.0
OL-12642-01
Preface
Related Documentation
For more information about Cisco Unified IP Phones or Cisco Unified Communications Manager, refer
to the following publications:
Cisco Unified IP Phone 7900 Series
These publications are available at the following URL:
http://www.cisco.com/en/US/products/hw/phones/ps379/tsd_products_support_series_home.html
• Cisco Unified IP Phone 7975 Series Phone Guide
• Cisco Unified IP Phone Features A–Z
Chapter 3, “Setting Up the Cisco
Unified IP Phone”
Describes how to properly and safely install and
configure the Cisco
Unified IP Phone on your
network.
Chapter 4, “Configuring Settings on the Cisco
Unified IP Phone”
Describes how to configure network settings,
verify status, and make global changes to the
Cisco
Unified IP Phone.
Chapter 5, “Configuring Features, Templates,
Services, and Users”
Provides an overview of procedures for
configuring telephony features, configuring
directories, configuring phone button and softkey
templates, setting up services, and adding users to
Cisco
Unified Communications Manager.
Chapter 6, “Customizing the Cisco Unified
IP Phone”
Explains how to customize phone ring sounds,
background images, and the phone idle display at
your site.
Chapter 7, “Viewing Model Information, Status,
and Statistics on the Cisco Unified IP Phone”
Explains how to view model information, status
messages, network statistics, and firmware
information from the
Cisco Unified IP Phone.
Chapter 8, “Monitoring the Cisco
Unified IP Phone Remotely”
Describes the information that you can obtain
from the phone’s web page. to remotely monitor
the operation of a phone and to assist with
troubleshooting.
Chapter 9, “Troubleshooting and Maintenance” Provides tips for troubleshooting the
Cisco
Unified IP Phone.
Appendix A, “Providing Information to Users Via
a Website”
Provides suggestions for setting up a website for
providing users with important information about
their Cisco
Unified IP Phones.
Appendix B, “Feature Support by Protocol for the
Cisco Unified IP Phone 7975G”
Provides information about feature support for the
Cisco Unified IP Phone 7975G using the SCCP or
SIP protocol with Cisco Unified Communications
Manager Release 6.0.
Appendix C, “Supporting International Users” Provides information about setting up phones in
non-English environments.
Appendix D, “Technical Specifications” Provides technical specifications of the
Cisco
Unified IP Phone.

Cisco 7975G Specifications

General

Handset type	Wired handset
Product type	IP Phone
Product color	Grey, Silver
Speakerphone	Yes
Voice codecs	G.711Mu, G.711a, G.722, G.729A, iLBC
Number of melodies	24
Aspect ratio	4:3
Display diagonal	5.6 \
Display resolution	320 x 240 pixels
Lines quantity	8 lines
Phonebook capacity	- entries
Number of VoIP accounts	-
Front camera	No
Security algorithms	128-bit AES
Networking standards	IEEE 802.1Q, IEEE 802.1p, IEEE 802.1x, IEEE 802.3af
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Ethernet LAN interface type	Gigabit Ethernet
Supported network protocols	DHCP, TFTP
Volume control	Digital
Headphone outputs	1
Ethernet LAN (RJ-45) ports	2
Number of handles included	1 pc(s)
AC adapter output voltage	48 V
Storage temperature (T-T)	-10 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 95 %
Certification	FCC

Weight and Dimensions

Depth	152.4 mm
Width	266.7 mm
Height	203.2 mm
Weight	1600 g