Cisco 7975G Administration Guide

2-11
Cisco Unified IP Phone 7975G Administration Guide for Cisco Unified Communications Manager 6.0
OL-12642-01
Chapter 2 Preparing to Install the Cisco Unified IP Phone on Your Network
Adding Phones to the Cisco Unified Communications Manager Database
Related Topics
• Adding Phones with Auto-Registration, page 2-9
• Adding Phones with Cisco Unified Communications Manager Administration, page 2-11
• Adding Phones with BAT, page 2-11
Adding Phones with Cisco Unified Communications Manager Administration
You can add phones individually to the Cisco Unified Communications Manager database using
Cisco
Unified Communications Manager Administration. To do so, you first need to obtain the MAC
address for each phone.
For information about determining a MAC address, see the “Determining the MAC Address of a Cisco
Unified IP Phone” section on page 2-13.
After you have collected MAC addresses, in Cisco Unified Communications Manager Administration,
choose Device > Phone and click Add New to begin.
For complete instructions and conceptual information about Cisco Unified Communications Manager,
refer to Cisco Unified
Communications Manager Administration Guide and to Cisco Unified
Communications Manager System Guide.
Related Topics
• Adding Phones with Auto-Registration, page 2-9
• Adding Phones with Auto-Registration and TAPS, page 2-10
• Adding Phones with BAT, page 2-11
Adding Phones with BAT
The Cisco Bulk Administration Tool (BAT) enables you to perform batch operations, including
registration, on multiple phones.
To add phones using BAT only (not in conjunction with TAPS), you first need to obtain the appropriate
MAC address for each phone.
For information about determining a MAC address, see the “Determining the MAC Address of a Cisco
Unified IP Phone” section on page 2-13.
For detailed instructions about using BAT, refer to Cisco Unified Communications Manager
Administration Guide and to Cisco Unified Communications Manager Bulk Administration Guide.
Related Topics
• Adding Phones with Auto-Registration, page 2-9
• Adding Phones with Auto-Registration and TAPS, page 2-10
• Adding Phones with Cisco Unified Communications Manager Administration, page 2-11

Cisco 7975G Specifications

General

Handset type	Wired handset
Product type	IP Phone
Product color	Grey, Silver
Speakerphone	Yes
Voice codecs	G.711Mu, G.711a, G.722, G.729A, iLBC
Number of melodies	24
Aspect ratio	4:3
Display diagonal	5.6 \
Display resolution	320 x 240 pixels
Lines quantity	8 lines
Phonebook capacity	- entries
Number of VoIP accounts	-
Front camera	No
Security algorithms	128-bit AES
Networking standards	IEEE 802.1Q, IEEE 802.1p, IEEE 802.1x, IEEE 802.3af
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Ethernet LAN interface type	Gigabit Ethernet
Supported network protocols	DHCP, TFTP
Volume control	Digital
Headphone outputs	1
Ethernet LAN (RJ-45) ports	2
Number of handles included	1 pc(s)
AC adapter output voltage	48 V
Storage temperature (T-T)	-10 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 95 %
Certification	FCC

Weight and Dimensions

Depth	152.4 mm
Width	266.7 mm
Height	203.2 mm
Weight	1600 g