Cisco 8800 Series

To Next Page

To Previous Page

Unless specified otherwise, the image is only for representational purposes. The rack's actual appearance and

size may vary.

Note

This image is only for representational purposes. Your grounding requirement depends on your building.

Note

Figure 2: Building with Rack Room Connected to Earth Ground

Hardware Installation Guide for Cisco 8800 Series Routers

Prepare for Installation

Prepare Your Location

Main Page

Table of Contents4
Unpack and Install the Chassis29
Unpack the Chassis29
Install Bottom-Support Rails33
Transfer Chassis to a Mechanical Lifting Device34
Mount Chassis into the Rack36
Locate and Ground the Chassis46
Install Cable Management on a Chassis51
Attach Front Door to Chassis62
Ground the Front Door66
Powering on the Router69
Power Module Overview69
Connect DC Power Supply to Power Source72
Connect HVAC/HVDC Power Supply to Power Source75
Power Supply Power Cord Specifications78
Power Cord Illustrations80
Connect Router to the Network83
Connecting a Console to the Router83
Connect the Management Interface84
Transceivers, Connectors, and Cables85
Transceiver and Cable Specifications85
RJ-45 Connectors85
Install and Remove QSFP Transceiver Modules86
Required Tools and Equipment87
Installing the Transceiver Module87
Attach the Optical Network Cable89
Removing the Transceiver Module91
Connect Interface Ports91
Connect a Fiber-Optic Port to the Network91
Disconnect Optical Ports from the Network92
Maintain Transceivers and Optical Cables92
Create the Initial Router Configuration92
Verify Chassis Installation94
Set Fabric Bandwidth Threshold101
Leds103
Chassis LED103
Port Status Leds103
Power Supply Leds104
Fan Tray Leds105
Temperature Warning Label106
Route Processor Card Leds107
Fabric Card Leds109
Line Card Leds110
Replace Chassis Components113
Replace Chassis Door Foam Air Filters113
Provision of Grace Period before Route Processor Shutdown from Ejector Lever115
Replace a Route Processor Card116
Replace a Line Card121
Replace a Fan Tray123
Remove Fan Tray123
Install Fan Tray123
Replace Fabric Card125
Remove a Fabric Card125
Install a Fabric Card128
Replace Power Supply Components131
Install Power Shelf Bezel131
Replace DC Power Module134
Disconnect DC Power135
Reconnect DC Power135
Replace HVAC and HVDC Power Module136

Cisco 8800 Series - Page 25

Table of Contents

Other manuals for Cisco 8800 Series

Related product manuals