Cisco 8800 Series Hardware Installation Guide

To ensure that power remains off while you are performing this procedure, lock-out/tag-out the DC circuit
breaker switch in the off (0) position until you are ready to turn it on.
Caution
Follow these steps to connect the DC source power cables to a DC power tray:
Procedure
Step 1 Verify that the power tray switch is set to the STANDBY (0) position.
Figure 55: DC Power Tray
Front2Rear1
Step 2 Remove the clear plastic safety covers that fit over the DC power connection terminal studs.
Hardware Installation Guide for Cisco 8800 Series Routers
68
Powering on the Router
Connect DC Power Supply to Power Source

Cisco 8800 Series Specifications

General

Protocols	SIP, SCCP
Audio	Wideband audio
Connectivity	Gigabit Ethernet
Power	Power over Ethernet (PoE)
Bluetooth	Yes
USB	Yes
Codec Support	G.711, G.722, G.729, iLBC
Dimensions	Varies by model
Weight	Varies by model
Wi-Fi	Yes (varies by model)