Chapter 2 Switch Installation
Where to Go Next
2-34
Catalyst 2970 Switch Hardware Installation Guide
OL-6422-01
Where to Go Next
If the default configuration is satisfactory, the switch does not need further
configuration. You can use any of these management options to change the default
configuration:
• Start the device manager, which is in the switch memory, to manage
individual and standalone switches. The device manager is an easy-to-use
web interface that offers quick configuration and monitoring. You can access
the device manager from anywhere in your network through a web browser.
For more information, see the device manager online help.
• Start the Network Assistant application, which is described in the Getting
Started with Cisco Network Assistant guide. Through this GUI, you can
configure and monitor a switch cluster or an individual switch.
• Use the CLI from the console to configure the switch as a member of a cluster
or as an individual switch. See the Catalyst 2970 Switch Software
Configuration Guide and the Catalyst 2970 Switch Command Reference on
Cisco.com for information on using the CLI with a Catalyst 2970 switch.
• Start an SNMP application such as the CiscoView application.
To Next Page
Loading...
