Cisco CRS Series - Page 86

40.
nsf
41.
mdt source interface-path-id
42.
interface all enable
43.
vrf name
44.
address-family {ipv4 | ipv6}
45.
bgp auto-discovery pim
46.
mdt default {ipv4 | ipv6} ipaddress partitioned bidir ipaddress
47.
interface all enable
48.
router pim [address-family {ipv4 | ipv6}]
49.
rp-address ip-address
50.
vrf name
51.
address-family {ipv4 | ipv6}
52.
rp-address ip-address [group-access-list] [bidir]
53.
commit
DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Enters interface configuration mode to define the
IPv4 address for the interface.
interface type interface-path-id
Example:
RP/0/RP0/CPU0:router(config)# interface loopback 1
Step 2
Enters interface configuration mode to define the
IPv4 address for the interface.
description line
Example:
RP/0/RP0/CPU0:router(config-if)# description
Step 3
"loopback interface on PE1"
Sets VRF in which the interface operates.
vrf vrf_name
Example:
RP/0/RP0/CPU0:router(config-if)# vrf vrf1
Step 4
Defines the IPv4 address for the interface.
{ipv4 | ipv6 address} address mask
Example:
RP/0/RP0/CPU0:router(config-if)# ipv4 address
Step 5
10.0.1.3 255.255.255.0
RP/0/RP0/CPU0:router(config-if)# ipv6 address
101:101::101:101/128
Cisco IOS XR Multicast Configuration Guide for the Cisco CRS Router, Release 5.2.x
76
Implementing Multicast Routing on Cisco IOS XR Software
Configuring MVPN GRE BIDIR