Cisco CRS Series - Page 87

PurposeCommand or Action
Configures the OSPF routing process.router ospf 100
Example:
RP/0/RP0/CPU0:router(config)# router ospf 100
Step 6
Enables Cisco Non Stop Forwarding.nsf cisco
Example:
RP/0/RP0/CPU0:router(config-ospf)# nsf cisco
Step 7
Redistributes information from another routing
protocol such as BGP.
redistribute bgp 100
Example:
RP/0/RP0/CPU0:router(config-ospf)# redistribute bgp
Step 8
100
Configures the area id and enters the OSFP area
configuration mode.
area area_id
Example:
RP/0/RP0/CPU0:router(config-ospf-ar)# area 0
Step 9
Enters interface configuration mode to define the
IPv4 address for the interface.
interface type interface-path-id
Example:
RP/0/RP0/CPU0:router(config)# interface loopback 1
Step 10
Similarly, configure multiple interfaces for
a multicast configuration.
Note
Configures the BGP routing process.router bgp 100
Example:
RP/0/RP0/CPU0:router(config)# router bgp 100
Step 11
Configures the router-id for the BGP protocol.
bgp router-id ip_address
Example:
RP/0/RP0/CPU0:router(config-bgp)# bgp router-id
Step 12
12.33.42.34
Enables graceful-restart support for the BGP
protocol.
bgp graceful-restart
Example:
RP/0/RP0/CPU0:router(config-bgp)# bgp
Step 13
graceful-restart
Cisco IOS XR Multicast Configuration Guide for the Cisco CRS Router, Release 5.2.x
77
Implementing Multicast Routing on Cisco IOS XR Software
Configuring MVPN GRE BIDIR