PurposeCommand or Action
Configures ipv4 address-family for unicast and enters
the address family command mode.
address-family {ipv4 | ipv6} unicast
Example:
RP/0/RP0/CPU0:router(config-bgp)# address-family
Step 14
ipv4 unicast
Redistributes information from another routing
protocol through connected routes.
redistribute connected
Example:
RP/0/RP0/CPU0:router(config-bgp-af)# redistribute
Step 15
connected
Configures ipv4 address-family for multicast and
enters the address family command mode.
address-family {ipv4 | ipv6} multicast
Example:
RP/0/RP0/CPU0:router(config-bgp)# address-family
Step 16
ipv4 multicast
Redistributes information from another routing
protocol through connected routes.
redistribute connected
Example:
RP/0/RP0/CPU0:router(config-bgp-af)# redistribute
Step 17
connected
Configures vpnv4 address-family for unicast and
enters the address family command mode.
address-family {vpnv4 | vpnv6} unicast
Example:
RP/0/RP0/CPU0:router(config-bgp)# address-family
Step 18
vpnv4 unicast
Configures ipv4 address-family for mdt and enters
the address family command mode.
address-family {ipv4 | ipv6} mdt
Example:
RP/0/RP0/CPU0:router(config-bgp)# address-family
Step 19
ipv4 mdt
Configures ipv4 address-family for mvpn and enters
the address family command mode.
address-family {ipv4 | ipv6} mvpn
Example:
RP/0/RP0/CPU0:router(config-bgp)# address-family
Step 20
ipv4 mvpn
Cisco IOS XR Multicast Configuration Guide for the Cisco CRS Router, Release 5.2.x
78
Implementing Multicast Routing on Cisco IOS XR Software
Configuring MVPN GRE BIDIR
To Next Page
Loading...
