PurposeCommand or Action
Specifies a neighbor router.
neighbor address
Example:
RP/0/RP0/CPU0:router(config-bgp)# neighbor 1.3.45.6
Step 21
Set remote AS with the specified 2-byte AS number.
remote-as 2-byte AS number
Example:
RP/0/RP0/CPU0:router(config-bgp-nbr)# remote-as 100
Step 22
Set remote AS with the specified 2-byte AS number.
update-source interface type interface-path-id
Example:
RP/0/RP0/CPU0:router(config-bgp-nbr)# update-source
Step 23
Loopback 1
Configures ipv4 address-family for unicast and enters
the address family command mode.
address-family {ipv4 | ipv6} unicast
Example:
RP/0/RP0/CPU0:router(config-bgp-nbr)# address-family
Step 24
ipv4 unicast
Applies the route policy named pass-all to inbound
routes.
route-policy name in
Example:
RP/0/RP0/CPU0:router(config-bgp-nbr-af)#
Step 25
route-policy pass-all in
Applies the route policy named pass-all to outbound
routes.
route-policy name out
Example:
RP/0/RP0/CPU0:router(config-bgp-nbr-af)#
Step 26
route-policy pass-all out
Configures ipv4 address-family for multicast and
enters the address family command mode.
address-family {ipv4 | ipv6} multicast
Example:
RP/0/RP0/CPU0:router(config-bgp)# address-family
Step 27
ipv4 multicast
RP/0/RP0/CPU0:router(config-bgp)# address-family
ipv6 unicast
Cisco IOS XR Multicast Configuration Guide for the Cisco CRS Router, Release 5.2.x
79
Implementing Multicast Routing on Cisco IOS XR Software
Configuring MVPN GRE BIDIR
To Next Page
Loading...
