Cisco CRS Series - Page 90

PurposeCommand or Action
Configures vpnv4 address-family for unicast and
enters the address family command mode.
address-family {vpnv4 | vpnv6} unicast
Example:
RP/0/RP0/CPU0:router(config-bgp)# address-family
Step 28
vpnv4 unicast
RP/0/RP0/CPU0:router(config-bgp)# address-family
vpnv6 unicast
Applies the route policy named pass-all to inbound
routes.
route-policy name in
Example:
RP/0/RP0/CPU0:router(config-bgp-nbr-af)#
Step 29
route-policy pass-all in
Applies the route policy named pass-all to outbound
routes.
route-policy name out
Example:
RP/0/RP0/CPU0:router(config-bgp-nbr-af)#
Step 30
route-policy pass-all out
Configures ipv4 address-family for mdt and enters
the address family command mode.
address-family {ipv4 | ipv6} mdt
Example:
RP/0/RP0/CPU0:router(config-bgp)# address-family
Step 31
ipv4 mdt
Configures ipv4 address-family for mvpn and enters
the address family command mode.
address-family {ipv4 | ipv6} mvpn
Example:
RP/0/RP0/CPU0:router(config-bgp)# address-family
Step 32
ipv4 mvpn
RP/0/RP0/CPU0:router(config-bgp)# address-family
ipv6 mvpn
Configures the VRF.
vrf name
Example:
RP/0/RP0/CPU0:router(config-bgp)# vrf vrf1
Step 33
Configures the route distinguisher.
rd x.y format
Example:
RP/0/RP0/CPU0:router(config-bgp-vrf)# rd 1:1
Step 34
Cisco IOS XR Multicast Configuration Guide for the Cisco CRS Router, Release 5.2.x
80
Implementing Multicast Routing on Cisco IOS XR Software
Configuring MVPN GRE BIDIR