PurposeCommand or Action
Configures ipv4 address-family for unicast and enters
the address family command mode.
address-family {ipv4 | ipv6} unicast
Example:
RP/0/RP0/CPU0:router(config-bgp-nbr)# address-family
Step 35
ipv4 unicast
RP/0/RP0/CPU0:router(config-bgp-nbr)# address-family
ipv6 unicast
Redistributes information from another routing
protocol through connected routes.
redistribute connected
Example:
RP/0/RP0/CPU0:router(config-bgp-af)# redistribute
Step 36
connected
Configures ipv4 address-family for mvpn and enters
the address family command mode.
address-family {ipv4 | ipv6} mvpn
Example:
RP/0/RP0/CPU0:router(config-bgp)# address-family
Step 37
ipv4 mvpn
RP/0/RP0/CPU0:router(config-bgp)# address-family
ipv6 mvpn
Enters multicast routing configuration mode.multicast-routing [address-family {ipv4 | ipv6}]
Example:
RP/0/RP0/CPU0:router(config)# multicast-routing
Step 38
address-family ipv4
RP/0/RP0/CPU0:router(config)# multicast-routing
address-family ipv6
Enables IP multicast for Loopback interface.
interface type interface-path-id enable
Example:
RP/0/RP0/CPU0:router(config-mcast-default-ipv4)#
Step 39
interface Loopback 0 enable
Configures global multicast Cisco Non Stop
Forwarding.
nsf
Example:
RP/0/RP0/CPU0:router(config-mcast-default-ipv4)#
Step 40
nsf
Specifies the interface used to set MDT source
address.
mdt source interface-path-id
Example:
RP/0/RP0/CPU0:router(config-mcast-default-ipv4)#
Step 41
mdt source Loopback 0
Cisco IOS XR Multicast Configuration Guide for the Cisco CRS Router, Release 5.2.x
81
Implementing Multicast Routing on Cisco IOS XR Software
Configuring MVPN GRE BIDIR
To Next Page
Loading...
