Chapter 5 Web GUI Setup and Monitoring
Adding a Trap Destination
1 Click Add in the Trap Destination Configuration area.
2 In the Trap Destination IP Address field, enter the IP address that sets the
destination for SNMP trap messages for system events (for example, fault
messages).
3 In the Community String field, enter the community string for the trap
destination (IP Address entered above).
Enter public or custom. The default is public. You can enter a string up to 35
characters.
4 Click Save.
To edit/delete an existing trap destination, select the trap destination entry by
clicking on the radio button. Make the necessary changes, or click Delete to remove
the address from the Trap Destination Configuration list.
To Next Page
Loading...
Need help?
General
