RS-232 Data Connector Pin Allocation
The table shows the RS-232 Data connector and the pin allocation:
Cue Tone/Cue Trigger Interface
The D9854/D9854-I receiver is equipped with a connector labeled Cue Tone/Relay
for alarm relay outputs for remote alarm signaling. This connector provides Cue
Tone, Cue Trigger and Alarm relay functionality. These outputs are user-
configurable via the Setup Menu on the front panel.
The connector is a 15-pin sub-D female connector. The following diagram shows the
connector and the pin allocation table for Cue Tone, Cue Trigger and Alarm relay
connections.
To Next Page
Loading...
Need help?
General
