Setting up Audio and Video Information
Setting up Cue Tone Test
1 From the user interface of the D9854/D9854-I, choose Audio & Video > Cueing
> Cue Tone Test. The Cue Tone Test page is displayed.
2 In the Test Tones field, specify the three digit tone sequence. You can enter a
value between 000 and 999.
3 From the Sequence Mode drop-down list, choose the tone sequence mode. The
following describes the available options:
- * - Start tone only
- # - End tone only
- */# - Start and end tones. The end tone is signaled after waiting the time
specified in Delay(sec).
4 Click Apply.
To Next Page
Loading...
